Bardzo dobra jakość skanu, przystępna cena. Instrukcja serwisowa okazała się przydatna przy "reanimowaniu" dwudziestoparoletniego decka, który teraz pięknie gra :)
Tekstowy podgląd strony 16 (kliknij aby zobaczyć)
Replacing the Lamp
* Connect your dealer or LG service center for replacing of new lamp. You must replace the lamp when:
¯
The projector image get darker or start to be deteriorated. The lamp indicator is red(red, flashing alternately). The massage �LAMP REPLACE� appears on the screen when turning the projector lamp on.
¯
¯
* Replace the lamp as below sequence 1. Turn off the projector and unplug the power cable. (Cool the lamp for more than 1 hour.) 2. Remove the four retaing screws on the lamp cover with a screwdriver of �+� type and then lift off the lamp cover. 3. After lifting the lamp cover off, remove the two retaing screw on lamp case with screwdriver of �-� type. (refer to fig.2) 4. Lift up the fixed wire handle of the lamp. (refer to fig.3) 5. Pull out the handle slowly and remove the lamp case. 6. Insert the new lamp gently into the correct position. Make sure it is inserted correctly. 7. Tighten the screw you removed in step 3. 8. Replace the lamp cover and tighten the cover screws.(Make sure the almp cover is securely fastend. If lamp cover is open, the lamp indicator flashes green and the projector is not turn on.)
< Fig. 1>
< Fig. 2>
* Resetting the lamp time After pressing the �?� key on the remote control in Stand-By mode, press the �9876� and press the �OK� button. And then three LED in the front is stop after flashing for a moment. < Fig. 3> * Lamp Life Time Confirmation 1. Method1 : Enter ADJ mode with using the remote control. You can be confirmed because � Lamp Life Time XX hr� is appeared. 2. Method2 : With using the remote control offerd to consumer if you press the menu button continuously, OSD menus will disappear then press the �9876� and press the �OK� button to enter ADJ mode you can see �Lamp Life Time XX hr�
